Init Unable 4f Brother Dcp J140w

Posted on by
  1. Brother Dcp 7060d Driver
  2. Init Unable 4f Brother Dcp-j140w
  3. Dcp J140w Driver
Init Unable 4f Brother Dcp J140w

Brother Dcp 7060d Driver

View and Download Brother DCP-J100 user manual online. Brother MFP User's guide. DCP-J100 all in one printer pdf manual download. Also for: Dcp-j105. Follow these instructions: Disconnect Brother Printer from power cord. Press OK button and while holding the OK button re-connect the printer to the power cord (electric source). Hi, I have a Brother MFC-640CW which has been working until recently. It is now displaying the warning message 'Unable to Init. See troubleshooting and routine maintenance chapter in User's Guide'. My Brother is a DCP-350C so the fix was a little different and involved the mono colour button. Not sure how I got to the correct place but I eventually did. Followed your instructions as far as they took me and then played around.

Lupe fiasco the cool rar. Customer Problem
The printer was down for while because it stopped initializing when turned on.

Diagnosis
When received the printer when put on was not initializing as was previously mentioned and giving an error on screen stating Unable to init.4f. When I searched the error online it did not have a very distinct reasoning for the problem except to do the following:

Access the internal maintenance mode by pressing the Menu/Set button, then press * 2 8 6 4 within 2 seconds. This should put you in the maintenance mode menu. Enter 80, and then scroll down with the arrow down (round) key. You’ll find an entry listed as purge count. If number is over 6000, enter 2 7 8 3.

Init Unable 4f Brother Dcp-j140w

Work Done
What I realized on this occassion is that the machine did not even get a chance for the rollers to start spinning. This made me check each area of the printer to see if anything was blocking the paper path or the gears controlling the rollers. I didnt find anything in particular so i forced the rollers into motion carefully spinning them in a clockwise motion as to mimic the printing process.

Dcp J140w Driver

Results
After checking all printer paths and gears and rollers, I powered it up again and as it came on you could hear the rollers going through the motions. Did some test prints and after some cleaning and alignment the printer was back to it self.